Poly Wall® Blue Barrier™ Liquid Wrap 2300 is a spray applied, fully adhered, permeable, air and moisture building envelope protection membrane. This thin mil, seamless substrate coating can be applied with an approved airless sprayer or power rolled. Liquid Wrap can be sprayed over surfaces and substrates such as OSB, plywood or exterior gypsum that have been prepared per the Poly Wall Blue Barrier Application Guides.
• Great replacement for housewraps
• Exceptional adhesion/Bonds to multiple substrates (OSB, plywood, gypsum, CMU)
• PERMEABLE/Allows substrates to breathe
• Low VOC/UV resistant
• Wet surface application/Bonds and cures in wet conditions
Why use Poly Wall® Blue Barrier™ Liquid Wrap 2300?
• 60 years of successful waterproofing experience
• When utilized with our Blue Barrier 2200 Joint Filler combines to fill in voids up to 3/4”
due to penetrations or dissimilar surfaces.
• Stands up to UV .... up to 9 months UV Exposure.
• Works as a complete system with our Blue Barrier 2400 Flash ‘N Wrap Window and Door
Fluid applied Flashing and Waterproofing treatment.
• Can be covered with commonly used cladding/siding systems including heavy
veneers.
• Same Technology has been used in Commercial Construction for years.
• Compliant with several NFPA 285 wall assemblies
Storage
12 months from manufacture date. Store below 80°F.
Limitations
• Apply as packaged. Do not dilute or alter.
• Properly dispose of any roller covers and brushes as they will not be reused or cleaned.
If you used the plastic trowel or putty knife allow for the product to cure and peel off
for the next use.
• When not dispensing the product, cover the bucket with a lid to ensure the
product is the viscosity you want.
• For optimum results, we recommend this product be applied in 40°F and rising
temperatures. However you likely (depending on RH) can apply is down to 25°F. Test
a small area to determine how it works on a given day when the temp is less than 40°.
• For extended storage: Prior to re-setting the lid linder, spray a nitrogen blanket to stop
the material from prematurely curing. This type of product can be found in “Key Board
Cleaner” at office supply stores. Just 2-3 short burst per application is all you need.
• Stains from substrate may transfer due to permeability of product but will not alter
performance of product.
Visit the Poly Wall Website for more information about this product.
